Exams › GATE › Technical

The most common limit gage used for inspecting the hole diameter is

1. Snap gage
2. Ring gage
3. Plug gage
4. Master gage

Correct answer: Plug gage

Solution

A plug gage is specifically designed to measure the internal diameter of holes, making it the most common tool for this purpose due to its accuracy and ease of use.

Related GATE Technical questions

• A block of mass 10 kg rests on a horizontal floor. The acceleration due to gravity is 9.81 m/s². The coefficient of static friction between the floor and the block is 0.2. A horizontal force of 10 N is applied on the block as shown in the figure. The magnitude of force of friction (in N) on the block is ____
• A cylindrical rod of diameter 10 mm and length 1.0 m is fixed at one end. The other end is twisted by an angle of 10° by applying a torque. If the maximum shear strain in the rod is p×10⁻³, then p is equal to ____ (round off to two decimal places).
• A rigid triangular body, PQR, with sides of equal length of 1 unit moves on a flat plane. At the instant shown, edge QR is parallel to the x-axis, and the body moves such that velocities of points P and R are Vp and Vr, in the x and y directions, respectively. The magnitude of the angular velocity of the body is
• Hardendability of steel is a measure of
• The fluidity of molten metal of cast alloys (without any addition of fluxes) increases with increase in
• The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative motion between the tool and the workpiece) to produce a roughened surface with a regular pattern is

⚔️ Practice GATE Technical free + battle 1v1 →