Exams › GATE › Technical

Which one of the following CANNOT impart linear motion in a CNC machine?

1. Linear motor
2. Ball screw
3. Lead screw
4. Chain and sprocket

Correct answer: Chain and sprocket

Solution

Chain and sprocket systems are typically used for transferring rotary motion rather than directly imparting linear motion, making them less suitable for CNC applications compared to the other options.

Related GATE Technical questions

• Equal sized circular regions are shaded in a square sheet of paper of 1 cm side length. Two cases, case M and case N, are considered as shown in the figures below. In the case M, four circles are shaded in the square sheet and in the case N, nine circles are shaded in the square sheet as shown. What is the ratio of the areas of unshaded regions of case M to that of case N?
• Which one of the following is the definition of ultimate tensile strength (UTS) obtained from a stress-strain test on a metal specimen?
• A structural member under loading has a uniform state of plane stress which in usual notations is given by σx = 3P, σy = −2P and τxy = √2 P, where P > 0. The yield strength of the material is 350 MPa. If the member is designed using the maximum distortion energy theory, then the value of P at which yielding starts (according to the maximum distortion energy theory) is
• Which one of the following is an intensive property of a thermodynamic system?
• Consider a steady flow through a horizontal divergent channel, as shown in the figure, with supersonic flow at the inlet. The direction of flow is from left to right. Pressure at location B is observed to be higher than that at an upstream location A. Which among the following options can be the reason?
• Which of the following non-dimensional terms is an estimate of Nusselt number?

⚔️ Practice GATE Technical free + battle 1v1 →