Exams › GATE › Technical
The correct sequence of machining large diameter through hole is
- drilling, boring, reaming
- boring, drilling, reaming
- drilling, reaming, boring
- boring, reaming, drilling
Correct answer: drilling, boring, reaming
Solution
The correct sequence starts with drilling to create the initial hole, followed by boring to achieve the desired diameter and finish, and finally reaming to enhance the hole's accuracy and surface quality.
Related GATE Technical questions
- In modern CNC machine tools, the backlash has been eliminated by
- In which of the following pairs of cycles isothermal process?
- Superheated steam at 1500 kPa, has a specific volume of 2.75 m³/kmol and compressibility factor (Z) of 0.95. The temperature of steam is ____ °C (round off to the nearest integer).
- An infinitely long pin fin, attached to an isothermal hot surface, transfers heat at a steady rate of Q̇1 to the ambient air. If the thermal conductivity of the fin material is doubled, while keeping everything else constant, the rate of steady-state heat transfer from the fin becomes Q̇2. The ratio Q̇2/Q̇1 is
- A cantilever beam of length, L, and flexural rigidity, EI, is subjected to an end moment, M, as shown in the figure. The deflection of the beam at x = L/2 is
- Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in the figure. This shear stress distribution represents
⚔️ Practice GATE Technical free + battle 1v1 →